Use the following to review solutions for issues that occur while setting rules for cox homelife.
Cox homelife door sensor not working.
Open and close the door or window.
For example the sensor has a low or bad battery.
Automatically locks after 30.
The cox homelife touchscreen message alerts table below describes how to define and resolve touchscreen alerts.
Xfinity for full functionality of this site it is necessary to enable javascript.
Disarm your cox homelife system prior to changing the battery in any of the devices.
All homelife devices can be easily and conveniently controlled from the homelife mobile app no matter where you are.
Use a glass break simulator if available.
Optional for homelife automation.
The seller has the keypad and there are door sensors and camera not sure what else.
Place the touchscreen into alarm test mode to prevent an alarm tamper condition.
If a sensor test is not in progress check the identified sensor to confirm everything is seated properly and unobstructed.
Call cox customer support to troubleshoot issues with your sensors.
The rule has a special character or symbol in the rule name.
Twist the screwdriver to pop off the sensor cover and set it aside.
Door or window is open.
Test button for the identified sensor was pressed.
Learn what to do when you have a problem with a door window sensor connected to your xfinity home system.
Adhere the sensor and magnet to your door or window.
She said the system is leased so i looked into it and it appears the keypad touchpad is leased but everything else should be owned.
System not ready to arm.
Cox homelife offers a variety of smart devices that can be connected to your homelife system including hd cameras smart door locks smart led light bulbs smart plugs and more.
Avoid the motion detector for three minutes after arming the system then walk in front of it.
Note the polarity shown in the battery compartment and match the and signs on the ends of the batteries to the signs inscribed in the battery compartment.
Remove the old battery and dispose of it properly as recommended by the battery manufacturer.
Now do the same with the magnet making sure the etched lines of the sensor and magnet line up.
Take the sensor and remove the other side of the adhesive protective strip.
Push the cover back on the sensor until it clicks into place.
Press and hold the sensor test button until the siren sounds approximately ten seconds.
Replace with the new battery.
The rule is based on a sensor that is not working.
